SATO HT200e Operator's Manual page 119

SECTION 6: ON LINE
TRANSFER OF PRESET DATA
The following are general procedures on how to transfer and register preset data from a host
computer.
1) With [6] pressing, turn the power "ON".
2) Press [ ] twice.
→
3) Select with [ ] and [
←
4) Select with [ ] and [
←
5) Data is being waited.
6) Preset data can be transmitted from a host computer.
7) When data is transmitted, it goes to the screen as below:
PRESET STR / RCALL
PRINTER HOST
← →
At the beginning of preset data, send SOH + 9 and transmit preset data for next item(s). When
data transmission is finished, send EOT for its termination.
When data sending is terminated, it goes back to the screen in the process No. 7 above. The
following chart summarizes the flow for the registration of preset data through SOH + 9.
HOST
SOH+9
STX to ETX
(For 1 preset)
STX to ETX
STX to ETX
EOT
Page 6-14
] for From HOST to HT and press [ENTR].
→
] for "Y" and press [ENTR].
→
HT
Start of registration
Registration for first item
Registration for second item
End of registration
Termination of registration process
SATO HT200e