SATO HT200e Operator's Manual page 73

SECTION 4 FREE MODE
：
FIELD DESIGNATION FOR NUMBER OF PRINTING
Based on the field designation, the setting, in which "00: Number of Print" is specified, is
described.
Digit Designated item
position (s)
1, 2 Field designation
3 Fixed quantity
(Case 1)
4 to Reserved
15
16 Count
(Case 2)
17 to Reserved
30
Important: "Field Designation = 00" must be specified, so that the field for the number of printing
will be placed in the last field. That is--if the fields from 1 to 3 have been set, the field No. 4 will be
arranged for the number of printing.
Case 1 W hen the fixed quantity "1" is selected:
Press ENTR to go to the Fixed Quantity display. Then enter all 4 digits in numbers.
Please note if the quantity is not properly specified, the function will not work appropri-
ately.
See the sample below, where 20 labels are fixed. The number on the upper left shows
the field No.
03 F IXED DATA
A dditional notes
〔 〕
If a unique format, in which fixed data in all fields must be fixed in all digits, is used for the
fixed quantity, one field without printing should be set aside as a place for return after printing.
(The field without printing can be prepared if "000" is specified as the vertical print position.)
Case 2 W hen the fixed quantity "1" is selected:
The count designation "0" (or the number of label entered will be printed) is only
available for setting.
Page 4-10
00: Field for Number of Printing
0: No fixed print quantity (It is regularly used)
1: Fixed print quantity
All must be set to 0.
The method of counting labels can be specified for a
dispense mode:
0: It prints the number of labels entered.
Other than 0: It can freely print because of no number is
specified.
All must be set to 0.
Description
03 F IXED DATA
0020
SATO HT200e