SATO HT200e Operator's Manual page 151

8. If you're using to suppress extra carriage returns and line feeds from your data being sent out
to the printer. We want the data stream to be one complete line going to the printer.
9. If you still are unable to get printer output, try the Hex Dump as described in Step 5 under the
Parallel Interface troubleshooting. In this case, the printer monitors the RS232C interface for
incoming data.
ERROR SIGNALS
The LCD Display provides a visual indication of the type of error encountered.
ERROR MESSAGE
MEDIA PITCH ERROR
COVER OPEN
CHARGE PWR PACK
PRINT BATT LOW
CHNG PRINT BATT
NO CARD SET
PLS CLEAR CARD
CARD BATT LOW
CHNG CARD BATT
WRITE PROTECT ON
CONFIRM CLR TYPE
BLANK FORMAT
DATA ERR
C/D VERIFY ERR
NO UPLOAD DATA
SATO HT200e
CAUSE
Did not detect label edge
Top cover is not latched
down
Main battery low
Memory battery on the pcb
is low
Memory battery on the pcb
is dead
No PCMCIA card
detected.
Data found on card.
PCMCIA card battery is
low
PCMCIA battery dead.
Cannot write to PCMCIA
card.
Improper clear procedure
Unregistered format num-
ber.
Entered data exceeds lim-
its.
Check digit incorrect
No data to upload
SECTION 9: TROUBLESHOOTING
CORRECTIVE ACTION
No paper
Improperly loaded paper
Sensor adjustment
Press firmly on the cover until
you hear a click.
Charge the battery
Replace the pcb battery. Backup
you printer data before changing.
Change battery. Data may be
lost.
Insert PCMCIA memory card in
the slot.
Clear the card in the data mainte-
nance mode.
Replace battery. Back up card
data before changing.
Replace battery. Data may be
lost.
Check to see if card is writing
protected.
Clear again.
Check to make sure format is
registered in the printer.
Re-enter correct data.
Re-enter correct check digit.
Make sure there is data
Page 9-3