D-Link xStack DES-3528 Series Cli Reference Manual page 140

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
config address_binding ip_mac ports
show address_binding
show address_binding blocked
show address_binding dhcp_snoop
show address_binding dhcp_snoop
binding_entry
show address_binding ip_mac
show address_binding nd_snoop
show address_binding nd_snoop
binding_entry
delete address_binding blocked
delete address_binding ip_mac
enable address_binding trap_log
disable address_binding trap_log
debug address_binding
no debug address_binding
enable address_binding dhcp_snoop
disable address_binding dhcp_snoop
enable address_binding nd_snoop
disable address_binding nd_snoop
clear address_binding dhcp_snoop
binding_entry ports
clear address_binding nd_snoop
binding_entry ports
show address_binding dhcp_snoop
show address_binding dhcp_snoop
binding_entry
config address_binding dhcp_snoop
max_entry ports
config address_binding nd_snoop ports
config address_binding recover_learning ports
Each command is listed, in detail, in the following sections.
create address_binding ip_mac ipaddress
Purpose
Syntax
Description
Parameters
Used to create an IP–MAC–Port Binding entry in the white list.
create address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr>
{ports [ <portlist> | all] | mode [ arp | acl ]}
This command is used to create an IP–MAC–Port Binding entry.
<ipaddr> – The IP address of the device where the IP–MAC–Port Binding is made.
[<portlist> | all] {state [enable {[strict | loose] | [ipv6 | all]} | disable
{[ipv6 | all]}] | mode [arp | acl] | allow_zeroip [enable | disable] |
forward_dhcppkt [enable | disable] | stop_learning_threshold
<int 0-500>}
{ports {<portlist>}}
[all | vlan_name <vlan_name> mac_address <macaddr>]
{max_entry {ports <portlist>}}
{port <port>}
[all | ipaddress <ipaddr> mac_address <macaddr>] | ipv6address
<ipv6addr> mac_address <macaddr>
{ports <portlist>}
{port <port>}
[all | vlan_name <vlan_name> mac_address <macaddr>]
[all | ipaddress <ipaddr> mac_address <macaddr>] | ipv6address
<ipv6addr> mac_address <macaddr>
[event | dhcp | all] state [enable | disable]
{[ipv6 | all]}
{[ipv6 | all]}
[<portlist> | all] {[ipv6 | all]}
[<portlist> | all]
{max_entry {ports <portlist>}}
{port <port>}
[<portlist> | all] limit [<value 1-50> | no_limit] {ipv6}
[< portlist > | all] max_entry [< value 1-10 > | no_limit]
[<portlist> | all]
140