Network Monitoring Commands - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
N M
ETWORK
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
show packet ports
show error ports
show utilization
show utilization dram
show utilization flash
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
config log_save_timing
show log_save_timing
show attack_log
clear attack_log
config system_severity
show system_severity
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Syntax
Description
Parameters
Restrictions
C
ONITORING
Parameters
<portlist>
<portlist>
[ports | cpu]
{unit <unit_id>}
{unit <unit_id>}
{ports <portlist>}
{[index <value_list> |severity {module <module_list>} {emergency | alert | critical |
error | warning | notice | informational | debug | <level_list 0-7>} | module
<module_list>]}
<index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity [emergency | alert | critical |
error | warning | notice | informational | debug | <level 0-7>] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> |
state [enable | disable]}
[<index> | all] {severity [emergency | alert | critical | error | warning | notice |
informational | debug | <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 |
local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress [<ipaddr>
|<ipv6addr>] | state [enable | disable]}
[<index 1-4> | all]
{<index 1-4>}
[time_interval <min 1-65535> | on_demand | log_trigger]
{unit <unit_id 1-8>} {index <value_list>}
{[unit <unit_id 1-8> | all]}
[trap | log | all] [emergency | alert | critical | error | warning | notice | information |
debug | <level 0-7>]
Used to display statistics about the packets sent and received by the Switch.
show packet ports <portlist>
This command is used to display statistics about packets sent and received by ports
specified in the <portlist>.
<portlist> − Specifies a port or range of ports to be displayed.
None.
OMMANDS
63