D-Link xStack DES-3528 Series Cli Reference Manual page 395

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
config wac ports
Restrictions
Example usage:
To configure port WAC state:
DES-3528:admin#config wac ports 1-8 state enable
Command: config wac ports 1-8 state enable
Success.
DES-3528:admin#
config wac switch_http_port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the WAC Switch http port:
DES-3528:admin#
Command: config wac switch_http_port 8888 http
Success.
DES-3528:admin#
config wac user
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure WAC user's VLAN:
idle_time – A time period after which an authenticated host will be moved to an un-
authenticated state if there is no traffic during that period. "infinite" indicates the host will not
be removed from the authenticated state due to the idle of traffic. The default value is infinite.
block_time – If a host fails to pass the authentication, it will be blocked for this period of time
before it can be re-authenticated. The default value is 60 seconds.
Only Administrator and Operator and Power-User-level users can issue this command.
Used to configure the TCP port that the WAC Switch listens to.
config wac switch_http_port < tcp_port_number 1-65535> {[http | https]}
This command is used to identify the HTTP or HTTPs packets that will be trapped to the
CPU for authentication processing, or to access the login page.
If not specified, the default port number for HTTP is 80, and the default port number for
HTTPS is 443.
If no protocol is specified, the protocol is HTTP.
The HTTP cannot run at TCP port 443, and the HTTPS cannot run at TCP port 80.
<tcp_port_number 1-65535> – A TCP port which the WAC Switch listens to and uses to
finish the authenticating process.
http – To specify that WAC runs HTTP protocol on this TCP port.
https – To specify that WAC runs HTTPS protocol on this TCP port.
Only Administrator and Operator and Power-User-level users can issue this command.
config wac switch_http_port 8888 http
Used to configure the VLAN ID of the user account.
config wac user <username 15> [vlan <vlan_name 32> | vlanid <vlanid 1-4094>] |
clear_vlan]
This command allows you to configure Web-based-function user setting.
username − The name of the user account to be changed.
vlan – Authentication VLAN name.
clear_vlan - To clear the VLAN that is configured previously.
Only Administrator and Operator and Power-User-level users can issue this command.
395