Appendixa - Password Recovery Procedure - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
A A - P
PPENDIX
This section describes the procedure for resetting passwords on D-Link Switches.
Authenticating any user who tries to access networks is necessary and important. The basic authentication method
used to accept qualified users is through a local login, utilizing a Username and Password. Sometimes, passwords get
forgotten or destroyed, so network administrators need to reset these passwords. This document will explain how the
Password Recovery feature can help network administrators reach this goal.
The following steps explain how to use the Password Recovery feature on D-Link devices to easily recover
passwords.
Complete these steps to reset the password:
1. For security reasons, the Password Recovery feature requires the user to physically access the device.
Therefore this feature is only applicable when there is a direct connection to the console port of the
device. It is necessary for the user needs to attach a terminal or PC with terminal emulation to the console
port of the Switch.
2. Power on the Switch. After the runtime image is loaded to 100%, the Switch will allow 2 seconds for the
user to press the hotkey [^] ( Shift + 6 ) to enter the "Password Recovery Mode". Once the Switch enters
the "Password Recovery Mode", all ports on the Switch will be disabled.
Boot Procedure
-------------------------------------------------------------------------------
Power On Self Test ........................................
MAC Address : 00-22-B0-10-8A-00
H/W Version : A2
Please wait, loading V2.60..017 Runtime image .............
Password Recovery Mode
>
3. In the "Password Recovery Mode" only the following commands can be used.
Command
reset config
reboot
reset account
reset password
{<username>}
show account
ASSWORD
Parameters
The reset config command resets the whole configuration will be back to the default value
The reboot command exits the Reset Password Recovery Mode and restarts the Switch. A
confirmation message will be displayed to allow the user to save the current settings.
The reset account command deletes all the previously created accounts.
The reset password command resets the password of the specified user. If a username is
not specified, the password of all users will be reset.
The show account command displays all previously created accounts.
R P
ECOVERY
512
ROCEDURE
V1.00.B008
100 %
100 %