D-Link xStack DES-3528 Series Cli Reference Manual page 69

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
DES-3528:admin# show syslog
Command: show syslog
Syslog Global State: Enabled
DES-3528:admin#
create syslog host
Purpose
Used to create a new syslog host.
Syntax create syslog host <index 1-4> ipaddress [<ipaddr> | <ipv6addr>] {severity
[emergency | alert | critical | error | warning | notice | informational | debug | <level 0-
7>] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | state [enable | disable]}
Description This command is used to create a new syslog host.
<index 1-4> − Specifies that the command will be applied to an index of hosts. There are four
Parameters
available indexes, numbered 1 through 4.
ipaddress <ipaddr> − Specifies the IP address of the remote host where syslog messages
will be sent.
<ipv6addr> - Specifies the IPv6 address used.
udp_port <udp_port_number> - Specifies the UDP port number used.
state [enable | disable] – Specifies the state of the Syslog host.
severity − Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the Switch.
Numerical
Code
0
1
2
3
4
5
6
7
facility − Some of the operating system daemons and processes have been assigned Facility
values. Processes and daemons that have not been explicitly assigned a Facility may use
any of the "local use" facilities or they may use the "user-level" Facility. Those Facilities that
have been designated are shown in the following: Bold font indicates the facility values the
Switch currently supports.
Numerical
Code
0
1
2
3
4
5
syslog
6
7
8
9
10
11
Severity
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
Warning: warning conditions
Notice: normal but significant condition
Informational: informational messages
Debug: debug-level messages
Facility
kernel messages
user-level messages
mail system
system daemons
security/authorization messages
messages generated internally by
line printer subsystem
network news subsystem
UUCP subsystem
clock daemon
security/authorization messages
FTP daemon
69
Numerical Facility
Code
12 NTP subsystem
13 log audit
14 log alert
15 clock daemon
16 local use 0 (local0)
17 local use 1 (local1)
18 local use 2 (local2)
19 local use 3 (local3)
20 local use 4 (local4)
21 local use 5 (local5)
22 local use 6 (local6)
23 local use 7 (local7)