D-Link xStack DES-3528 Series Cli Reference Manual page 253

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
config flow_meter
rate - This specifies the rate for single rate two color mode. Specify the committed bandwidth
in Kbps for the flow.
<value 0-1048576> - Enter the rate for single rate two color mode here. This value must be
between 0 and 1048576.
burst_size - (Optional) This specifies the burst size for the single rate two color mode. The
unit is Kbytes.
<value 0-16384> - Enter the burst size value here. This value must be between 0 and 16384.
rate_exceed - This specifies the action for packets that exceed the committed rate in single
rate two color.
drop_packet - Drop the overflow packets immediately.
remark_dscp - Mark the packet with a specified DSCP. The packet is set to have a high drop
precedence.
<value 0-63> - Enter the remark DSCP value here. This value must be between 0 and 63.
tr_tcm - Specifies the "two rate three color mode".
cir - Specifies the "Committed Information Rate". The unit is in Kbps. CIR should always be
equal or less than PIR.
<value 0-1048576> - Enter the commited information rate value here.
cbs - (Optional) Specifies the "Committed Burst Size". The unit is Kbytes. That is to say, 1
means 1Kbytes. This parameter is an optional parameter. The default value is 4Kbyte.
<value 0-16384> - Enter the commited burst size value here.
pir - Specifies the "Peak Information Rate". The unit is in Kbps. PIR should always be equal
to or greater than CIR.
<value 0-1048576> - Enter the peak information rate value here.
pbs - (Optional) Specifies the "Peak Burst Size". The unit is in Kbytes. This parameter is an
optional parameter. The default value is 4Kbyte.
<value 0-16384> - Enter the peak burst size value here.
conform - (Optional) Specifies the action when a packet is mapped to the "green" color.
permit - Permits the packet.
replace_dscp - Changes the DSCP of the packet.
<value 0-63> - Enter the replace DSCP value here.
counter - (Optional) Specifies the ACL counter. This is optional. The default is "disable". The
resource may be limited so that a counter cannot be turned on. Counters will be cleared
when the function is disabled.
enable - Specifies that the ACL counter option will be enabled.
disable - Specifies that the ACL counter option will be disabled.
exceed - Specifies the action when a packet is mapped to the "yellow" color.
permit - Permits the packet.
replace_dscp - Changes the DSCP of the packet.
<value 0-63> - Enter the replace DSCP value here.
drop - Drops the packet.
counter - (Optional) Specifies the ACL counter. This is optional. The default is "disable". The
resource may be limited so that a counter cannot be turned on. Counters will be cleared
when the function is disabled.
enable - Specifies that the ACL counter option will be enabled.
disable - Specifies that the ACL counter option will be disabled.
violate - Specifies the action when a packet is mapped to the "red" color.
permit - Permits the packet.
replace_dscp - Changes the DSCP of the packet.
<value 0-63> - Enter the replace DSCP value here.
drop - Drops the packet.
counter - (Optional) Specifies the ACL counter. This is optional. The default is "disable". The
resource may be limited so that a counter cannot be turned on. Counters will be cleared
253