D-Link xStack DES-3528 Series Cli Reference Manual page 144

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
config address_binding ip_mac ports
Restrictions
Example usage:
To enable port 1 address_binding state:
DES-3528:admin# config address_binding ip_mac ports 1 state enable
Command: config address_binding ip_mac ports 1 state enable
Success.
DES-3528:admin#
To enable port 1 address_binding state and set mode to acl:
DES-3528:admin# config address_binding ip_mac ports 1 state enable mode acl
Command: config address_binding ip_mac ports 1 state enable mode acl
Success.
DES-3528:admin#
To enable port 1 address_binding state and set stop_learning_threshold to 60:
DES-3528:admin# config address_binding ip_mac ports 1 state enable
stop_learning_threshold 60
Command: config address_binding ip_mac ports 1 state enable
stop_learning_threshold 60
Success.
DES-3528:admin#
show address_binding
Purpose This command is used to display the IP–MAC–Port Binding entries.
show address_binding {ports {<portlist>}}
Syntax
Description This command is used to display the IP–MAC–Port Binding entries.
Parameters ports – Specifies the list of ports used for this display.
Restrictions None.
Example usage:
To show IP–MAC–Port Binding global configuration:
DES-3528:admin#show address_binding
Command: show address_binding
Trap/Log
DHCP Snoop(IPv4)
DHCP Snoop(IPv6)
ND Snoop
DES-3528:admin#
entries and will not allow additional MAC entries, both legal or illegal, to be learned on this
port. In the stop learning state, the port will also automatically purge all blocked MAC
entries on this port. Traffic from legal MAC entries are still forwarded. Entering 0 means
no limit has been set and the port will keep learning illegal MAC addresses.
<portlist> − Specifies a port or range of pors to be configured.
all – Specifies all ports on the Switch.
Only Administrator, Operator and Power User-level users can issue this command.
: Disabled
: Disabled
: Disabled
: Disabled
144