D-Link xStack DES-3528 Series Cli Reference Manual page 162

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
delete ipif
Description
Parameters
Restrictions
Example usage:
To delete an IP interface.
DES-3528:admin# delete ipif if2
Command: delete ipif if2
Success.
DES-3528:admin#
enable ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the admin state of the System interface .
DES-3528:admin# enable ipif System
Command: enable ipif System
Success.
DES-3528:admin#
disable ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the admin state of the System interface.
DES-3528:admin# disable ipif System
Command: disable ipif System
Success.
This command deletes an interface or all interfaces.
Note that the system interface cannot be deleted.
<ipif_name 12> − The name of the deleted IP interface.
all – All IPIF except the System IPIF will be deleted.
ipv6address <ipv6networkaddr> - Specifies the IPv6 address used.
Only Administrator, Operator and Power User-level users can issue this command.
Used to enable the admin state for an interface.
enable ipif [<ipif_name 12> | all]
This command enables the state for an IPIF.
When the state is enabled, the IPv4 processing will be started. When the IPv4 address is
configured on the IPIF.
<ipif_name 12> − The name of the IP interface.
all – All the interface.
Only Administrator, Operator and Power User-level users can issue this command.
Used to disable the admin state for an interface.
disable ipif [<ipif_name 12> | all ]
This command disables the state for an ipif.
<ipif_name 12> − The name of the IP interface.
all – Specifies all interfaces.
Only Administrator, Operator and Power User-level users can issue this command.
162