xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
show erps
The RPL owner administrative state could be configured to "Enabled" or "Disabled". But the
RPL owner operational state may be different from the RPL owner administrative state, for
example, the RPL owner conflict occurs. "Active" is used to indicate that the RPL owner
administrative state is enabled and the device is operated as the active RPL owner. "Inactive"
is used to indicate that the RPL owner administrative state is enabled, but the device is
operated as the inactive RPL owner.
Parameters
raps_vlan - (Optional) Specifies the R-APS VLAN.
<vlanid> - Enter the VLAN ID used here.
sub_ring - (Optional) Display the sub-ring configuration information.
Restrictions
None.
Example usage:
To display ERPS information:
DES-3528:admin#
Command: show erps
Global Status
Log Status
Trap Status
------------------------
R-APS VLAN
Ring Status
West Port
East Port
RPL Port
RPL Owner
Protected VLANs
Ring MEL
Holdoff Time
Guard Time
WTR Time
Current Ring State
------------------------
R-APS VLAN
Ring Status
West Port
East Port
RPL Port
RPL Owner
Protected VLANs
Ring MEL
Holdoff Time
Guard Time
WTR Time
Current Ring State
------------------------
Total Ring: 2
DES-3528:admin#
Command: show erps raps_vlan 4092 sub_ring
R-APS VLAN: 4092
Sub-Ring R-APS VLAN
-------------------
4093
DES-3528:admin#
config erps trap
Purpose
This command is used to configure trap state of ERPS events.
show erps
: Enabled
: Disabled
: Disabled
: 4092
: Enabled
: 5 (Blocking)
: 7 (Forwarding)
: West Port
: Enabled (Active)
: 100-300, 4092, 4093
: 2
: 0 milliseconds
: 500 milliseconds
: 5 minutes
: Idle
: 4093
: Enabled
: Virtual Channel
: 10 (Forwarding)
: None
: Disabled
: 200-220
: 2
: 0 milliseconds
: 500 milliseconds
: 5 minutes
: Idle
show erps raps_vlan 4092 sub_ring
TC Propagation State
---------------------
Enable
484