D-Link xStack DES-3528 Series Cli Reference Manual page 371

Layer 2 managed stackable fast ethernet switch
Hide thumbs Also See for xStack DES-3528 Series:
Table of Contents

Advertisement

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
config rspan vlan
Parameters
Restrictions
Example usage:
To configure the rx traffic of port 2 to port 5 mirrored and add vid tag 2 :
DES-3528:admin# config rspan vlan vlan_name v3 source add ports 2-5 rx
Command: config rspan vlan vlan_name v3 source add ports 2-5 rx
Success.
DES-3528:admin#
show rspan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display special setting:
DES-3528:admin# show rspan vlan_id 63
Command: show rspan vlan_id 63
RSPAN
: Enabled
RSPAN VLAN ID : 63
-------------------
Source Ports
membership is specified, the RSPAN VLAN tag will be removed. The redirect function will
only work when RSPAN is enabled. Multiple RSPAN VLANs can be configured with redirect
settings at the same time.
NOTE: If RSPAN is enabled, the packets mirrored to the destination port
are always added with an RSPAN VLAN tag. If mirror is enabled but
RSPAN is disabled, the packets mirrored to the destination port may be
in tagged form or in untagged form.
NOTE: Only one RSPAN VLAN can be configured with source settings.
vlan – Specify the RSPAN VLAN on the source Switch.
vlan_name – Specify RSPAN VLAN by VLAN name.
vlan_id – Specify RSPAN VLAN by VLAN ID.
redirect – Specify ouptut port for the RSPAN VLAN packets.
source – Specify the source settings for the RSPAN VLAN on the source Switch.
add – Add source ports into the RSPAN source.
delete – Delete source ports from the RSPAN source.
ports – Specify source portlist to add to or delete from the RSPAN source.
rx – Only monitor ingress packets.
tx – Only monitor egress packets.
both – Monitor both ingress and egress packets.
Only Administrator and Operator-level users can issue this command.
Used to display RSPAN configuration.
show rspan {[vlan_name <vlan_name> | vlan_id <vlanid 1-4094>]}
This command displays the RSPAN configuration.
vlan_name – Specify the RSPAN VLAN by VLAN name.
vlan_id – Specify the RSPAN VLAN by VLAN ID.
None.
371

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents