D-Link xStack DES-3528 Series Cli Reference Manual page 444

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
Example usage:
DES-3528:admin#
Command: show cfm remote_mep mepname mep1 remote_mepid 2
Remote MEPID
MAC Address
Status
RDI
Port Status Defect
Interface Status Defect
Last CCM Serial Number
Sender Chassis ID
Sender Management Address: None
Detect Time
DES-3528:admin#
show cfm fault
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display cfm fault:
DES-3528:admin# show cfm fault
Command: show cfm fault
MD Name MA Name
----------- ----------- ----- ---------------------------
op_domain op1
DES-3528:admin#
show cfm port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display cfm ports:
DES-3528:admin# show cfm port 1
show cfm remote_mep mepname mep1 remote_mepid 2
: 2
: 00-22-B0-7A-24-B9
: OK
: No
: Up
: No
: 59
: None
: 2009-11-16 09:50:52
Used to show fault MEPs.
show cfm fault {md <string 22> {ma <string 22>}}
This command displays all the fault conditions detected by the MEPs contained in the
specified MA or MD. This display provides the overview of fault status by MEPs.
md – Specifies the maintenance domain name.
ma – Specifies the maintenance association name.
None.
MEPID Status
1 Cross-connect CCM Received
Used to show MEPs and MIPs created on a port.
show cfm port <port> {level <int 0-7> | direction [inward | outward] | vlanid <vlanid 1-
4094>}
This command is used to show MEPs and MIPs created on a port.
port – Specifies the port number.
level – Specifies the MD Level. If not specified, all levels are shown.
direction – Specifies the MEP direction.
inward – Inward facing MEP.
outward – Outward facing MEP.
If not specified, both directions and MIPs are shown.
vlanid – Specifies the VLAN identifier. If not specified, all VLANs are shown.
None.
444