D-Link xStack DES-3528 Series Cli Reference Manual page 485

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
config erps trap
Syntax config erps trap [enable | disable]
Description This command is used to configure trap state of ERPS events.
Parameters trap - Specifies to enable or disable the ERPS trap state.
enable - Enter enable to enable the trap state.
disable - Enter disable to disable the trap state. The default value is disabled.
Restrictions Only Administrator, Operator and Power User-level users can issue this command.
Example usage:
To configure the trap state of the ERPS:
DES-3528:admin#
Command: config erps trap enable
Success.
DES-3528:admin#
config erps raps_vlan state
Purpose
This command is used to configure ring state of the specified ring.
Syntax config erps raps_vlan <vlanid> state [enable | disable]
Description When both the global state and the specified ring ERPS state are enabled, the specified ring
will be activated. STP and LBD should be disabled on the ring ports before the specified ring
is activated.
The ring cannot be enabled before the R-APS VLAN is created, and ring ports, RPL port,
RPL owner, are configured. Note that these parameters cannot be changed when the ring is
activated.
In order to guarantee correct operation, the following integrity will be checked when the ring is
enabled and the global ERPS state is enabled.
1.
2.
3.
Parameters raps_vlan - Specifies the R-APS VLAN.
<vlanid> - Enter the VLAN ID used here.
state - Specifies to enable or disable the specified ring.
enable - Enable the state of the specified ring.
disable - Disable the state of the specified ring. The default value is disabled.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the ring state of the ERPS:
DES-3528:admin# config erps raps_vlan 4094 state enable
Command: config erps raps_vlan 4094 state enable
Success.
DES-3528:admin#
config erps raps_vlan sub_ring
Purpose This command is used to configure a sub-ring connected to another ring.
Syntax config erps raps_vlan <vlanid> [add | delete] sub_ring raps_vlan <vlanid>
Description This command is applied on the interconnection node.
config erps trap enable
R-APS VLAN is created.
The Ring port is the tagged member port of the R-APS VLAN.
The RPL port is specified if RPL owner is enabled.
485