D-Link xStack DES-3528 Series Cli Reference Manual page 77

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
Command
config stp nni_bpdu_addr
show stp mst_config_id
Each command is listed, in detail, in the following sections.
enable stp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable STP, globally, on the Switch:
DES-3528:admin# enable stp
Command: enable stp
Success.
DES-3528:admin#
disable stp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable STP on the Switch:
DES-3528:admin# disable stp
Command: disable stp
Success.
DES-3528:admin#
config stp version
Purpose
Syntax
Description
Parameters
Restrictions
Parameters
[dot1d | dot1ad]
Used to globally enable STP on the Switch.
enable stp
This command allows the Spanning Tree Protocol to be globally enabled on the Switch.
None.
Only Administrator and Operator and Power-User-level users can issue this command.
Used to globally disable STP on the Switch.
disable stp
This command allows the Spanning Tree Protocol to be globally disabled on the Switch.
None.
Only Administrator and Operator and Power-User-level users can issue this command.
Used to globally set the version of STP on the Switch.
config stp version [mstp | rstp | stp]
This command allows the user to choose the version of the spanning tree to be implemented
on the Switch.
mstp – Selecting this parameter will set the Multiple Spanning Tree Protocol (MSTP) globally
on the Switch.
rstp − Selecting this parameter will set the Rapid Spanning Tree Protocol (RSTP) globally on
the Switch.
stp − Selecting this parameter will set the Spanning Tree Protocol (STP) globally on the
Switch.
Only Administrator and Operator and Power-User-level users can issue this command.
77