Simple Red Commands - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
S RED C
IMPLE
The Simple RED commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
enable sred
disable sred
config sred
show sred
show sred drop_counter
config dscp trust
show dscp trust
config dscp map
show dscp map
config 802.1p map
show 802.1p map
1p_color
Each command is listed, in detail, in the following sections.
enable sred
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To enable sred:
DES-3528:admin# enable sred
Command: enable sred
Success.
DES-3528:admin#
disable sred
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To disable sred:
OMMANDS
Parameters
[<portlist> | all] [<class_id 0-7> | all] { threshold {low <value 0-100> | high<value 0-
100>}(1) | drop_rate {low<value 1-8> | high<value 1-8>}(1) | drop_green [enable |
disable]}(1)
{ <portlist>{ <class_id 0-7>}}
{<portlist>}
[<portlist> | all] state [enable | disable]
{<portlist>}
{[<portlist> | all]} [dscp_priority <dscp_list> to <priority 0-7> | dscp_dscp <dscp_list> to
<dscp 0-63> | dscp_color <dscp_list> to [green | red | yellow]]
{ <portlist> } [dscp_priotity | dscp_dscp | dscp_color] {dscp <dscp_list>}
{[<portlist> | all]} 1p_color <priority_list> to [green | red | yellow]
{ <portlist>}
Used to enable the simple RED function.
enable sred
This command is usded to enable the sRED function. By default, sRED is disabled.
None.
Only Administrator and Operator and Power-User-level users can issue this command.
Used to disable the simple RED function.
disable sred
This command is used to disable the sRED function.
None.
Only Administrator and Operator and Power-User-level users can issue this command.
375