D-Link xStack DES-3528 Series Cli Reference Manual page 142

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
create address_binding ip_mac ipv6address
Restrictions
Example usage:
To create a static IPv6 IMPB entry:
DES-3528:admin# create address_binding ip_mac ipv6address fe80::240:5ff:fe00:28
mac_address 00-00-00-00-00-11
Command: create address_binding ip_mac ipv6address fe80::240:5ff:fe00:28 mac_address
00-00-00-00-00-11
Success.
DES-3528:admin#
config address_binding ip_mac ipv6address
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a static IPv6 IMPB entry:
DES-3528:admin# config address_binding ip_mac ipv6address fe80::240:5ff:fe00:28
mac_address 00-00-00-00-00-11
Command: config address_binding ip_mac ipv6address fe80::240:5ff:fe00:28 mac_address
00-00-00-00-00-11
Success.
DES-3528:admin#
config address_binding ip_mac ports
Purpose
Syntax
Description
<macaddr> – The MAC address of the device where the IP–MAC–Port binding is made.
<portlist> – Specifies a port or range of ports to be configured for address binding.
all – Specifies that all ports on the Switch will be configured for address binding.
Only Administrator, Operator and Power User-level users can issue this command.
Used to configure an IP–MAC–Port Binding entry.
config address_binding ip_mac ipv6address <ipv6addr> mac_address <macaddr>
{ports [<portlist> | all]}
This command is used to configure an IP–MAC–Port Binding entry.
<ipv6addr> – The IP address of the device where the IP–MAC–Port binding is made.
<macaddr> – The MAC address of the device where the IP–MAC–Port binding is made.
<portlist> –Specifies a port or range of ports to be configured for address binding, if no
port is specified it will apply to all ports.
all – Specifies that all ports on the Switch will be configured for address binding.
Only Administrator, Operator and Power User-level users can issue this command.
Used to configure IMPB settings for specified ports.
config address_binding ip_mac ports [<portlist> | all] {state [enable {[strict | loose]
| [ipv6 | all]} | disable {[ipv6 | all]}] | mode [arp | acl] | allow_zeroip [enable | disable]
| forward_dhcppkt [enable | disable] | stop_learning_threshold <int 0-500>}
This command is used to configure the per-port state of IP-MAC binding on the Switch. If
a port has been configured as a group member of an aggregated link, then it cannot
enable the IP-MAC binding function.
When IMPB is enabled on a port, IP packets and ARP packets received by this port will
be checked depending on the setting. The packet will be dropped if its IP-MAC pair does
not match the IMPB white list.
Due to some special cases that have arisen with the IP–MAC–Port Binding, this Switch
142