D-Link xStack DES-3528 Series Cli Reference Manual page 331

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
config sim_group
add <candidate_id> <password> − Use this parameter to change a candidate Switch (CaS) to
Parameters
a member Switch (MS) of a SIM group. The CaS may be defined by its ID number and a
password (if necessary).
delete <member_id 1-32> − Use this parameter to delete a member Switch of a SIM group.
The member Switch should be defined by ID number.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To add a member:
DES-3528:admin# config sim_group add 2
Command: config sim_group add 2
Please wait for ACK!!!
SIM Configure Success !!!
Success.
DES-3528:admin#
To delete a member:
DES-3528:admin# config sim_group delete 1
Command: config sim_group delete 1
Please wait for ACK!!!
SIM Configure Success!!!
DES-3528:admin#
config sim
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Used to configure role parameters for the SIM protocol on the Switch.
config sim [{[commander {group_name <groupname 64> | candidate] | dp_interval
<30-90> | hold_time <sec 100-255>}]
This command is used to configure parameters of Switches of the SIM.
commander – Use this parameter to configure the commander Switch (CS) for the following
parameters:
group_name <groupname 64> − Used to update the name of the group. Enter an

alphanumeric string of up to 64 characters to rename the SIM group.

dp_interval <30-90> – The user may set the discovery protocol interval, in seconds
that the Switch will send out discovery packets. Returning information to the CS will
include information about other Switches connected to it. (Ex. MS, CaS). The user
may set the dp_interval from 30 to 90 seconds.

hold time <sec 100-255> – Using this parameter, the user may set the time, in
seconds, the CS will hold information sent to it from other Switches, utilizing the
discovery interval protocol. The user may set the hold time from 100 to 255 seconds.
candidate – Used to change the role of a CS (commander) to a CaS (candidate).

dp_interval <30-90> – The user may set the discovery protocol interval, in seconds
that the Switch will send out discovery packets. Returning information to the CS will
include information about other Switches connected to it. (Ex. MS, CaS). The user
may set the dp_interval from 30 to 90 seconds.

hold time <100-255> – Using this parameter, the user may set the time, in seconds,
the Switch will hold information sent to it from other Switches, utilizing the discovery
interval protocol. The user may set the hold time from 100 to 255 seconds.
Only Administrator-level users can issue this command.
331