D-Link xStack DES-3528 Series Cli Reference Manual page 51

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
DES-3528:admin# show snmp v6host
Command: show snmp v6host
SNMP Host Table
------------------------------------------------------------------
Host IPv6 Address : 3FFE::3
SNMP Version
Community Name/SNMPv3 User Name : initial
Host IPv6 Address : 3FFE::2
SNMP Version
Community Name/SNMPv3 User Name : private
Host IPv6 Address : 3FFE::1
SNMP Version
Community Name/SNMPv3 User Name : public
Host IPv6 Address : 3FFE::3
SNMP Version
Community Name/SNMPv3 User Name : user123
Host IPv6 Address : 3FFE::3
SNMP Version
Community Name/SNMPv3 User Name : user234
Total Entries: 5
DES-3528:admin#
create trusted_host
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create the trusted host:
DES-3528:admin# create trusted_host 10.62.32.1
Command: create trusted_host 10.62.32.1
Success.
config trusted_host
Purpose
Syntax
Description
Parameters
: V3 na/np
: V2c
: V1
: V3 a/np
: V3 a/ p
Used to create the trusted host.
create trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] {snmp | telnet | ssh | http | https | ping}
This command creates the trusted host. The Switch allows users to specify up to four IP
addresses that are allowed to manage the Switch via in-band SNMP or TELNET based
management software. These IP addresses must be members of the Management VLAN. If
no IP addresses are specified, then there is nothing to prevent any IP address from
accessing the Switch, provided the user knows the Username and Password.
<ipaddr> − The IP address of the trusted host to be created.
<network_address> − IP address and netmask of the trusted host to be created.
Only Administrator and Operator-level users can issue this command.
Used to configure the access interfaces for the trusted host.
config trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] [add | delete] {snmp | telnet | ssh | http | https | ping | all}
Used to configure the access interfaces for the trusted host.
<ipaddr> - The IP address of the trusted host.
<ipv6addr> - The IPv6 address of the trusted host.
51