Using the Command Line Interface (CLI)
Parameter Tables
–
MAC Access Control Parameters
–
Rogue Scan Configuration Table
–
Hardware Configuration Reset
–
VLAN/SSID Parameters
–
Security Profile Table
authentication mechanisms.
•
Other Parameters
–
IAPP Parameters
–
Wireless Multimedia Enhancements (WME)/Quality of Service (QoS) parameters
Enhancement/Quality of Service parameters, QoS policies, mapping priorities, and EDCA parameters. Apply a configured QoS policy
to a particular SSID.
System Parameters
Name
System
Name
Location
Contact Name
Contact E-mail
Contact Phone
FLASH Backup Interval
Flash Update
System OID
Descriptor
Up Time
Emergency Restore to defaults
- Control wireless access based on MAC address
- Enable and configure Rogue Scan to detect Rogue APs and clients.
- Disable or enable hardware configuration reset and configure a configuration reset password.
- Enable the configuration of multiple subnetworks based on VLAN ID and SSID pairs.
- Configure Security Profiles that define allowed security modes (wireless clients), and encryption and
- Enable or disable the Inter-Access Point Protocol
Type
Values
Group
N/A
DisplayString
User Defined
DisplayString
User Defined
DisplayString
User Defined
DisplayString
User Defined
DisplayString
User Defined
max 254 characters
Integer
0 - 65535 seconds
0
1
DisplayString
N/A
DisplayString
System Name, flash
version, S/N, bootloader
version
Integer
dd:hh:mm:ss
dd – days
hh – hours
mm – minutes
ss – seconds
Resets all parameters to
default factory values
- Enable and configure Wireless Multimedia
Access
CLI Parameter
R
system
RW
sysname
RW
sysloc
RW
sysctname
RW
sysctemail
RW
sysctphone
RW
sysflashbckint
RW
sysflashupdate
R
sysoid
R
sysdescr
R
sysuptime
RW
sysresettodefaults
Note: You must enter the
following command twice to
reset to defaults:
set sysresettodefaults 1
AP-4000 User Guide
158