Set Ethernet Speed And Transmission Mode - Proxim AP-4000 User Manual

Using the Command Line Interface (CLI)
Other Network Settings
Shutdown/Resume Wireless Service
[Device-Name]>set wif <index> wssstatus <1 (resume)/2 (shutdown)>
Set Load Balancing Maximum Number of Clients
[Device-Name]>set wif <index> lbmaxclients <1-63>
Set the Multicast Rate (802.11a)
[Device-Name]>set wif 3 multrate <6, 12, 24
Set the Multicast Rate (802.11b/g)
[Device-Name]>set wif 4 multrate <1,2,5.5,11
Enable/Disable Super Mode (802.11a/g only)
[Device-Name]>set wif 3 super <enable/disable>
Enable/Disable Turbo Mode (802.11a/g only)
[Device-Name]>set wif 3 turbo <enable/disable>
NOTE
Super mode must be enabled on the interface before Turbo mode can be enabled.
Configure Antenna Diversity
[Device-Name]>set wif 3 atdiversity <3, 4, 5(auto)>
[Device-Name]>set wif 4 atdiversity <1, 2, 5(auto)>
[Device-Name]>reboot
Set the Distance Between APs
[Device-Name]>set wif <index> distaps <1-5> (see below)
[Device-Name]>reboot 0
Value Distance Between APs
1 Large
2 Medium
3 Small
4 Mini
5 Micro

Set Ethernet Speed and Transmission Mode

[Device-Name]>set etherspeed <value> (see below)
[Device-Name]>reboot 0
Ethernet Speed and Transmission Mode
10 Mbits/sec - half duplex
10 Mbits/sec - full duplex
10 Mbits/sec - auto duplex
100 Mbits/sec - half duplex
(Mbits/sec)
(Mbits/sec)
Value
10halfduplex
10fullduplex
10autoduplex
100halfduplex
>
>
AP-4000 User Guide
150