Dhcp Server Parameters; Dhcp Relay Group - Proxim AP-4000 User Manual

Using the Command Line Interface (CLI)
Parameter Tables

DHCP Server Parameters

Name
DHCP Server
DHCP Server Status
Gateway IP Address
Primary DNS IP Address IpAddress
Secondary DNS IP
Address
Number of IP Pool Table
Entries
NOTE
The DHCP Server (dhcpstatus) can only be enabled after a DHCP IP Pool table entry has been created.
DHCP Server table for IP pools
Name
DHCP Server IP Address
Pool Table
Table Index
Start IP Address
End IP Address
Width
Default Lease Time
(optional)
Maximum Lease Time
(optional)
Comment (optional)
Status (optional)
NOTE
Set either End IP Address or Width (but not both) when creating an IP address pool.

DHCP Relay Group

The DHCP Relay Group allows you to enable or disable DHCP Relay Agent Status.
Name
DHCP Relay Group
Status
DHCP Relay Server Table
Type Values
Group N/A
Integer enable (1) (default)
disable (2)
delete (3)
IpAddress User Defined
User Defined
IpAddress User Defined
Integer32 N/A
Type Values
Table N/A
Integer User Defined
IpAddress User Defined
IpAddress User Defined
Integer User Defined
Integer32 > 0
86400 sec (default)
Integer32 > 0
86400 sec (default)
DisplayString User Defined
Integer enable (1)
disable (2)
delete (3)
Type Values
Group N/A
Integer Enable
Disable
Table
Access CLI Parameter
R dhcp
RW dhcpstatus
RW dhcpgw
RW dhcppridnsipaddr
RW dhcpsecdnsipaddr
R dhcpippooltblent
Access CLI Parameter
R dhcpippooltbl
N/A index
RW startipaddr
RW endipaddr
RW width
RW defleasetm
RW maxleasetm
RW cmt
RW status
Access CLI Parameter
R dhcprelay
RW dhcprelaystatus
R dhcprelaytbl
AP-4000 User Guide
160