Proxy Arp Parameters; Ip Arp Filtering Parameters; Broadcast Filtering Table; Tcp/Udp Port Filtering - Proxim AP-4000 User Manual

Using the Command Line Interface (CLI)
Parameter Tables

Proxy ARP Parameters

Name
Proxy ARP
Status

IP ARP Filtering Parameters

Name
IP ARP Filtering
Status
IP Address
Subnet Mask

Broadcast Filtering Table

Name
Broadcast Filtering
Table
Index
Protocol Name
Direction
Status

TCP/UDP Port Filtering

The following parameters are used to enable/disable the Port filter feature.
Name
Port Filtering
Port Filter Status
TCP/UDP Port Filtering Table
The following parameters are used to configure TCP/UDP Port filters.
Name
Port Filtering Table
Table Index
Port Type
Port Number
Type Values
Group N/A
Integer enable
disable (default)
Type Values
Group N/A
Integer enable
disable (default)
IpAddress User Defined
IpAddress User Defined
Type Values
Table N/A
Integer 1-5
DisplayString N/A
Integer ethertowireless
wirelesstoether
both (default)
Integer enable
disable (default)
Type Values
Group N/A
Integer enable (default)
disable
Type Values
Table N/A
N/A User Defined
(there are also 4
pre-defined indices, see
Port Number
more information)
Octet String tcp
udp
tcp/udp
Octet String User Defined
(there are also 4
pre-defined protocols:
Index 1: NetBios Name
Service – 137, Index 2:
NetBios Datagram
Service – 138, Index 3:
NetBios Session
Service – 139, Index 4:
SNMP Service – 161)
Access CLI Parameter
R parp
RW parpstatus
Access CLI Parameter
R iparp
RW iparpfltstatus
RW iparpfltipaddr
RW iparpfltsubmask
Access CLI Parameter
R broadcastflttbl
N/A index
R protoname
RW direction
RW status
Access CLI
R portflt
RW portfltstatus
Access CLI
R portflttbl
R index
below for
RW porttype
RW portnum
AP-4000 User Guide
172