Configure Dhcp Relay; Configure Dhcp Relay Servers; Maintain Client Connections Using Link Integrity; Change Your Wireless Interface Settings - Proxim AP-4000 User Manual
Orinoco ap-4000 access point user guide
Hide thumbs
Also See for AP-4000:
- User manual (274 pages) ,
- Specification sheet (2 pages) ,
- Configuration manual (6 pages)
Table of Contents
Advertisement
Using the Command Line Interface (CLI)
Other Network Settings
[Device-Name]>show dns
Figure A-14 Results of "show dns" CLI command
Configure DHCP Relay
Perform the following command to enable or disable DHCP Relay Agent Status.
NOTE
You must have at least one entry in the DHCP Relay Server Table before you can set the DHCP Relay Status to Enable.
[Device-Name]>set dhcprelaystatus enable
Configure DHCP Relay Servers
Perform the following command to configure and enable a DHCP Relay Server. The AP allows the configuration of a maximum of 10 server
settings in the DHCP Relay Agents server table.
[Device-Name]>set dhcprlyindex 1 dhcprlyipaddr <ip address> dhcprlycmt <comment> dhcprlystatus 1 (1 to
enable, 2 to disable, 3 to delete, 4 to create)
Maintain Client Connections using Link Integrity
[Device-Name]>show linkinttbl (this shows the current links)
[Device-Name]>set linkinttbl <1-5 (depending on what table row you wish to address)>
ipaddr <ip address of the host computer you want to check>
[Device-Name]>set linkintpollint <the interval between link integrity checks>
[Device-Name]>set linkintpollretx <number of times to retransmit before considering
the link down>
[Device-Name]>set linkintstatus enable
[Device-Name]>show linkinttbl (confirm new settings)
[Device-Name]>reboot 0
Change your Wireless Interface Settings
See
Interfaces
for information on the parameters listed below. The AP-4000 uses index 3 for Wireless Interface A (802.11a radio) and index 4
for Wireless Interface B (802.11b/g radio).
Operational Mode
[Device-Name]>set wif <index> mode <see table>
Mode
1
2
3
Autochannel Select (ACS)
ACS is enabled by default. Reboot after disabling or enabling ACS.
[Device-Name]>set wif <index> autochannel <enable/disable>
[Device-Name]>reboot 0
Enable/Disable Closed System
[Device-Name]>set wif <index> closedsys <enable/disable>
Operational Mode
dot11b-only
dot11g-only
dot11bg
AP-4000 User Guide
149
Advertisement
Table of Contents
