Performing Advanced Configuration
Interfaces
Interfaces
From the Interfaces tab, you configure the Access Point's power control settings, wireless interface settings and Ethernet settings. You can
configure the operational mode and the Transmit Power Control settings for each radio. You may also configure a Wireless Distribution
System for AP-to-AP communications. The Interfaces tab contains the following sub-tabs:
•
Operational Mode
–
Super Mode and Turbo Mode
–
Enable 802.11d: enables IEEE 802.11d support for additional regulatory domains. Refer to the
Regulatory Domains
–
ISO/IEC 3166-1 CountryCode: the country (regulatory domain) where the AP is located.
–
Enable TX Power Control: enables TX Power Control to control transmit power of 802.11-enabled clients within an IBSS. Refer to
the
TX Power Control
–
Transmit Power Level: the power level of the interface when IBSS Power Control is enabled. Allowed values are 100%, 50%, 25%,
or 12.5%.
•
Wireless-A (802.11a Radio) and Wireless-B (802.11b/g Radio)
•
Ethernet
and
Configuring 802.11d Support
and
Configuring TX Power Control
sections.
sections.
AP-4000 User Guide
IEEE 802.11d Support for Additional
44