Proxim AP-4000 User Manual page 165

Using the Command Line Interface (CLI)
Parameter Tables
802.11b/g Only Parameters
Name
Wireless Operational Mode
Operating Frequency Channel
Supported Data Rates
Transmit Rate
Physical Layer Type
SuperMode
TurboMode
Note 1: Super Mode must be enabled first on the wireless interface before Turbo Mode can be enabled.
Wireless Distribution System (WDS) Parameters
Name
WDS Table
Port Index
Status
Partner MAC Address
Type Values
Integer dot11b-only
dot11g-only
dot11bg (default)
Integer 1 - 14; available
channels vary by
regulatory
domain/country; see
802.11g Channel
Frequencies
Octet String See
below
Integer32 For 802.11b-only mode:
0 (auto fallback - default)
1 Mbits/sec
2 Mbits/sec
5.5 Mbits/sec
11 Mbits/sec
For 802.11g-only mode:
0 (auto fallback - default)
6 Mbits/sec
9 Mbits/sec
12 Mbits/sec
18 Mbits/sec
24 Mbits/sec
36 Mbits/sec
48 Mbits/sec
54 Mbits/sec
For 802.11bg mode:
0 (auto fallback - default)
1 Mbits/sec
2 Mbits/sec
5.5 Mbits/sec
11 Mbits/sec
6 Mbits/sec
9 Mbits/sec
12 Mbits/sec
18 Mbits/sec
24 Mbits/sec
36 Mbits/sec
48 Mbits/sec
54 Mbits/sec
Integer ERP (Extended Rate
Protocol)
Integer enable
disable (default)
Integer enable
disable (default)
Type Values
Table N/A
Integer 3.1 - 3.6 (Wireless)
Integer enable, disable
PhysAddress User Defined
Access CLI Parameter
RW mode
RW channel
Transmit Rate, R suppdatarates
RW txrate
R phytype
RW supermode
RW turbomode
Access CLI Parameter
R wdstbl
R portindex
RW status
RW partnermacaddr
AP-4000 User Guide
165