Set Rogue Scan Parameters - Proxim AP-4000 User Manual
Orinoco ap-4000 access point user guide
Hide thumbs
Also See for AP-4000:
- User manual (274 pages) ,
- Specification sheet (2 pages) ,
- Configuration manual (6 pages)
Table of Contents
Advertisement
Using the Command Line Interface (CLI)
Other Network Settings
Server Status
Server Addressing Format
IP Address/Host Name
Destination Port
VLAN Identifier
MAC Address Format
Response Time
Maximum Retransmission
Authorization Lifetime
Accounting Update Interval
Accounting Inactivity Timer
Index
Primary/Backup
Profile Name
Server Status
Server Addressing Format
IP Address/Host Name
Destination Port
VLAN Identifier
MAC Address Format
Response Time
Maximum Retransmission
Authorization Lifetime
Accounting Update Interval
Accounting Inactivity Timer
Set Rogue Scan Parameters
Perform the following command to enable or disable Rogue Scan on a wireless interface and configure the scanning parameters.
The cycletime parameter is only configured for background scanning mode.
[Device-Name]>set rscantbl <3, 4> mode <1 for background scanning, 2 for continuous scanning> cycletime
<cycletime from 1-1440 minutes> status <enable, disable>
NOTE
Rogue Scan cannot be enabled on a wireless interface when the Wireless Service Status on that interface is shutdown. First, resume
service on the wireless interface.
: notReady
: ipaddr
: 0.0.0.0
: 1812
: -1
: dashdelimited
: 3
: 3
: 0
: 0
: 5
: 4
: Backup
: Management Access
: notReady
: ipaddr
: 0.0.0.0
: 1812
: -1
: dashdelimited
: 3
: 3
: 0
: 0
: 5
AP-4000 User Guide
155
Advertisement
Table of Contents
