System Parameters - Proxim ORiNOCO AP-700 User Manual

Command Line Interface (CLI)
Parameter Tables

System Parameters

Name
System
Name
Location
Country Identifier*
Contact Name
Contact E-mail
Contact Phone
FLASH Backup Interval
Flash Update
System OID
Descriptor
Up Time
System Security ID
Emergency Restore to
defaults
* Available only on APs with model numbers ending in -WD. When available, this object must be configured before any interface parameters
can be set.
Country Identifiers
NOTE: All countries may not be available on your AP.
Country
Austria
Belgium
Cyprus
Czech Republic
Denmark
Estonia
Type
Group N/A
DisplayString User Defined
DisplayString User Defined
DisplayString See
below
DisplayString User Defined
DisplayString User Defined
DisplayString User Defined
max 254 characters
Integer 0 - 65535 seconds
0
1
DisplayString N/A
DisplayString System Name, flash
version, S/N, bootloader
version
Integer dd:hh:mm:ss
dd - days
hh - hours
mm - minutes
ss - seconds
DisplayString Retrieved from flash ID
Resets all parameters to
default factory values
Indoor/Outdoor
Indoor AT1
Outdoor AT2
Indoor BE1
Outdoor BE2
Indoor CY1
Outdoor CY2
Indoor CZ1
Outdoor CZ2
Indoor DK1
Outdoor DK2
Indoor EE1
Outdoor EE2
Value Access
R
RW
RW
Country Identifiers RW
RW
RW
RW
RW
RW
R
R
R
R
RW
Identifier
AP-700 User Guide
CLI Parameter
system
sysname
sysloc
sysworldcountrycode
sysctname
sysctemail
sysctphone
sysflashbckint
sysflashupdate
sysoid
sysdescr
sysuptime
sysinvmgmtsecurityid
sysresettodefaults
Note: You must enter the
following command twice to
reset to defaults:
set sysresettodefaults 1
213