Configure Syslog; Configure Intra Bss; Configure Mac Access Control - Proxim AP-4000 User Manual

Using the Command Line Interface (CLI)
Other Network Settings
Configure Serial Port Interface
NOTE
To avoid unexpected performance issues, leave Flow Control at the default setting (none) unless you are sure what this setting
should be.
[Device-Name]>set serbaudrate <2400, 4800, 9600, 19200, 38400, 57600>
[Device-Name]>set serflowctrl <none, xonxoff>
[Device-Name]>show serial
Figure A-15 Result of "show serial" CLI Command

Configure Syslog

[Device-Name]>set syslogpriority <1-7 (default is 6)>
[Device-Name]>set syslogstatus <enable/disable>
[Device-Name]>set sysloghbstatus <enable/disable> (default is disable)
[Device-Name]>set sysloghbinterval <1 - 604800> (default is 900 seconds)
[Device-Name]>set sysloghosttbl <index> ipaddr <ipaddress> cmt <comment> status <enable/disable>

Configure Intra BSS

[Device-Name]>set intrabssoptype <passthru (default)/block)>

Configure MAC Access Control

Setup MAC (Address) Access Control
[Device-Name]>set aclstatus enable/disable
[Device-Name]>set macacloptype <passthru, block>
[Device-Name]>reboot 0
Add an Entry to the MAC Access Control Table
[Device-Name]>set macacltbl <index> macaddr <MAC Address> status enable
[Device-Name]>show macacltbl
Disable or Delete an Entry in the MAC Access Control Table
[Device-Name]>set macacltbl <index> status <disable/delete>
[Device-Name]>show macacltbl
NOTE
For larger networks that include multiple Access Points, you may prefer to maintain this list on a centralized location using the
RADIUS parameters (see Set RADIUS Parameters).
AP-4000 User Guide
152