Set System Name, Location And Contact Information; Set Static Ip Address For The Ap; Change Passwords - Proxim AP-4000 User Manual
Orinoco ap-4000 access point user guide
Hide thumbs
Also See for AP-4000:
- User manual (274 pages) ,
- Specification sheet (2 pages) ,
- Configuration manual (6 pages)
Table of Contents
Advertisement
Using the Command Line Interface (CLI)
Set Basic Configuration Parameters using CLI Commands
•
Set System Name, Location and Contact Information
•
Set Static IP Address for the AP
•
Download an AP Configuration File from your TFTP Server
•
Set up Auto Configuration
•
Set Network Names for the Wireless Interface
•
Enable 802.11d Support and Set the Country Code
•
Enable and Configure TX Power Control for the Wireless Interface(s)
•
Configure SSID (Network Name) and VLAN Pairs, and Profiles
•
Download an AP Configuration File from your TFTP Server
•
Backup your AP Configuration File
Set System Name, Location and Contact Information
[Device-Name]>set sysname <system name> sysloc <Unit Location>
[Device-Name]>set sysctname <Contact Name (person responsible for system)>
[Device-Name]>set sysctphone <Contact Phone Number> sysctemail <Contact E-mail address>
[Device-Name]>show system
Figure A-12 Result of "show system" CLI Command
Set Static IP Address for the AP
NOTE
The IP Subnet Mask of the AP must match your network's Subnet Mask.
[Device-Name]>set ipaddrtype static
[Device-Name]>set ipaddr <fixed IP address of unit>
[Device-Name]>set ipsubmask <IP Mask>
[Device-Name]>set ipgw <gateway IP address>
[Device-Name]>show network
Change Passwords
[Device-Name]>passwd <Old Password> <New Password> <Confirm Password> (CLI password)
[Device-Name]>set httppasswd <New Password> (HTTP interface password)
[Device-Name]>set snmprpasswd <New Password> (SNMP read password)
[Device-Name]>set snmprwpasswd <New Password> (SNMP read/write)
[Device-Name]>set snmpv3authpasswd <New Password> (SNMPv3 authentication password)
[Device-Name]>set snmpv3privpasswd <New Password> (SNMPv3 privacy password)
[Device-Name]>reboot 0
!
CAUTION
Proxim strongly urges you to change the default passwords to restrict access to your network devices to authorized personnel. If you
lose or forget your password settings, you can always perform the
Reset to Factory Default
Procedure.
AP-4000 User Guide
144
Advertisement
Table of Contents
