Performing Advanced Configuration
Interfaces
Ethernet
Select the desired speed and transmission mode from the drop-down menu. Half-duplex means that only one side can transmit at a time and
full-duplex allows both sides to transmit. When set to auto-duplex, the AP negotiates with its switch or hub to automatically select the highest
throughput option supported by both sides.
Figure 4-15 Ethernet Sub-tab
For best results, Proxim recommends that you configure the Ethernet setting to match the speed and transmission mode of the device the
Access Point is connected to (such as a hub or switch). If in doubt, leave this setting at its default, auto-speed-auto-duplex. Choose
between:
•
10 Mbit/s - half duplex or full duplex
•
100 Mbit/s - half duplex or full duplex
•
Auto speed - auto duplex
AP-4000 User Guide
53