Initiating A Conference Via Lines - Tenovis Integral T3 User Manual

Initiating a conference via lines*

Initiating a conference via lines*

It is only possible to set up a conference via lines if there is an active connection and a con-
nection on hold. A "Conference" function key must also be set up:
Press the "Conference" function key.
Press the line key for the connection on hold (within 3 seconds).
• No multiline functions are available during a refer-back call or conference. That is why
the following functions are not possible during a refer-back call or conference:
- Manual hold
- Retrieving subscribers put on hold
- Picking up a call on another line
- Seizing a new line
In these cases the message "Function not possible" appears on the information line. The
multiline functions are fully available again after ending the refer-back call or conference.
• Detailed information on setting up function keys can be found in the section
gning functions to keys
• "Initiating a conference via lines" must be set up in the system.
Consult Tenovis Service if necessary.
↑
[ 113].
Telephoning with Multiline*
titledAssi-
98