Setting the CTI application (T3 IP only)
Setting the CTI application (T3 IP only)
The "TAPI" CTI application is set on your telephone by default. This means that you do not
need to make any further settings in order to run a TAPI application (e.g. Tenovis Com4Tel).
You must proceed as follows however, if another CTI application has been connected:
Press the "Menu" function key.
Scroll to the Settings menu item.
Confirm your selection.
Scroll to the CTI application (TAPI) menu item.
Confirm your selection.
Scroll to the Other CTI menu item.
Confirm your selection. You now need to make additional settings for this CTI application
via the "CTI setup" menu item, such as the protocol type or dialling method.
• You can find out how to log on a CTI application in the section
↑
cation*
[
151].
Auxiliary devices*
titledLogging on a CTI appli-
169