Log Set Installation - kozy heat 56701 Installation And Operation Manual

#TRF-500A LOG SET INSTALLATION
ATTENTION: If installing optional brick refractory please do so now before installing log set. Follow instructions included with kit.
If converting to LP (propane) gas do so now before installing log set. Follow instructions included with kit.
NOTE: Log numbers are located on bottom of each log. Refer to following instructions and illustrations for proper placement.
CAUTION: Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
soot to build up on logs and glass.
LP GAS MODELS (only)
If installing an optional firebrick refractory set, the break-away tab at front of LP
log plate will need to be removed. Position LP log plate onto back log bracket.
When properly seated, sides of log plate sit between back log brackets and burner
heat shield sides.
#1 LOG PLACEMENT
Place #1 log onto back log brackets, aligning log bracket pins with alignment holes in bottom of log while positioning notched out section
of log over pilot shield. Set down onto mounting pins.
LP GAS MODELS: Position back log to create 1/4" (6 mm) air space between back of burner and front of log.
NATURAL GAS MODELS: Position back log so front side of log is resting against backside of burner tube.
Figure 28b
#2 & #3 LOG PLACEMENT
Place left side alignment hole on base log #2, and right side alignment hole on base log #3 over pins on front log brackets, positioning
cut-outs on logs over log grate. Press logs down onto pins.
3
Figure 28c
1
2
BURNER HEAT SHIELD
Figure 28a
PAGE 28
LP LOG PLATE
BREAK-AWAY TAB
BACK LOG BRACKET