Log Set Installation - kozy heat JORDAN XL Installation And Operation Manual

#JXL-500 LOG SET INSTALLATION
NOTE: Log numbers are located on bottom of each log. Refer to following instructions and illustrations for proper placement.
CAUTION: Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
soot to build up on logs and glass.
JX2
Align holes in bottom of JX1, JX2, and JX3 logs with corresponding mounting studs on burner assembly, set down into position.
Align cut-out on bottom of JX4 log with jumper tube in center of burner assembly.
Figure 19a
Use a steel or stiff bristle nylon brush to distribute Rock Wool Embers onto logs and burner.
Aligning with notches in base logs, position JX8 - JX12 logs as shown above.
Use a steel or stiff bristle nylon brush to distribute additional Rock Wool Embers onto logs and burner.
Figure 19b
JX5
JX6
Place JX5, JX6 and JX7 logs as shown above.
JX8
JX11
PAGE 19
JX1
JX4
JX12
JX9
JX3
JX7
JX10