Conversion Kit Instructions - kozy heat 56701 Installation And Operation Manual

CONVERSION KIT INSTRUCTIONS (

#OCK-A38N-I-TRF-PSE NAT GAS CONVERSION KIT / #OCK-A625L-I-TRF-PSE LP GAS CONVERSION KIT
WARNING: This conversion kit shall be installed by a qualified service agency in accordance with the manufacturers instructions and
all applicable codes and requirements of the authority having jurisdiction. If the information in these instructions is not
followed exactly, a fire, explosion or production of carbon monoxide may result, causing property damage, personal injury
or loss of life. The qualified service agency is responsible for proper installation of this kit. The installation is not proper and
complete until operation of the converted appliance is checked as specified in the instructions supplied with the kit. Refer to
appliance owner‟s manual or product data plate for proper inlet and manifold pressure adjustments and orifice sizing.
Kit includes:
(1) Gas Conversion Label
(1) Pilot Orifice: NAT #.018 / LP #.012
WARNING: SHUT OFF GAS SUPPLY AND ELECTRICAL POWER TO FIREPLACE.
SHUT OFF GAS SUPPLY BEFORE DISCONNECTING ELECTRICAL POWER.
PREPARE FIREPLACE:
1. Remove upper hood, upper louver and glass assembly*.
2. Remove logs from fireplace.
3. IF CONVERTING TO NAT GAS: Remove LP log plate (if installed).
4. Remove pilot shield.
5. Remove burner tube from fireplace.
REPLACE BURNER ORIFICE:
1. Remove existing orifice cap and replace with orifice cap included with kit, making
sure to tighten cap securely.
CONVERT PILOT ASSEMBLY:
1. Remove (2) screws securing pilot assembly to pilot bracket. Place 7/16" wrench
on upper fitting and 1/2" wrench onto lower fitting, turn pilot hood nut
counter-clockwise to remove pilot hood.
2. Remove pilot orifice located inside lower fitting and replace with one included
with kit.
3. Re-attach pilot hood. Tighten with wrenches, making sure pilot hood is positioned
as shown in Figure 60d. Final alignment of sensor and hood outlet is critical for
proper ignition.
4. Attach pilot assembly to pilot bracket with screws previously removed.
GAS TYPE CONVERSION:
Press and hold Learn Button on the Main Control Module for 20 seconds.
A beep will be heard letting you know the procedure has been completed.
If converting from NAT to LP gas: one (1) second long beep
If converting from LP to Nat gas: three (3) second long beep
(1) Burner Orifice: NAT #38 / LP #.0625
(1) Low Limit Screw: NAT #48 / LP #55
PAGE 60
56701-IPI units only)
(1) Gas Label
LP PLATE
PILOT ASSEMBLY
BURNER ORIFICE
Figure 60a
Lower fitting
Figure 60b
Pilot orifice:
Remove existing,
replace with one
included with kit
Figure 60c
Sensor
Align
Hood outlet
Figure 60d
Upper fitting
pilot bracket