Table of Contents
Advertisement
8.2 #SP34-50A Log Set Installation
CAUTION: Do not place logs directly over burner port holes. Improper
log placement may affect flame appearance and cause excessive soot
to build upon the logs and glass.
•
If converting to propane, complete the conversion before
installing the log set. Follow the conversion instructions included
with the kit.
•
Log numbers are located on the bottom of each log. Refer to the
following instructions and illustrations for proper log placement.
1.
Place log SP34-1A on the back log plate.
2.
Align the holes in log SP34-2A with the mounting pins on the left
front log plate. Push log down to seat.
Figure 8.1, Base Logs
Figure 8.2, Installed Set
34 FIREPLACE SETUP
3.
Align the holes in log SP34-3A with the mounting pins on the
right front log plate. Push log down to seat.
4.
Distribute lava rock in front of the burner. Do not block burner
ports or airspaces.
5.
Align log SP34-4A with the notches in logs SP34-1A and SP34-2A
as shown.
6.
Align log SP34-5A with the notches in logs SP34-1A, SP34-2A,
and SP34-3A as shown.
7.
Align log SP34-6A with the notch in log SP34-3A and place as
shown.
8.
Distribute rockwool embers onto the logs and burner using a
stiff bristle brush. DO NOT block the area as shown below.
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
DO NOT distribute rockwool in this area.
#SP-34 L & MV R.9 April 2022
Advertisement
Table of Contents
