Table of Contents
Advertisement
9.5 NK41-500 Log Set Installation
NOTE: Log numbers are located on the bottom or side of each log. Refer to the following instructions and illustration for proper
placement. Your components may look different than the ones shown.
CAUTION: Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and may cause
excessive soot to build upon the glass.
•
If converting to propane, complete the
conversion before installing the log set.
Follow the conversion instructions includ-
ed with the kit.
•
If installing a panel set, complete installa-
tion of panel set before log installation
•
Install all light bulbs into the front and
rear ember bed light kits before log in-
stallation.
1. Remove valance from fireplace. Remove
the (4) screws securing the log rack / em-
berbed panel.
2. Remove the left and right burner assem-
bly by loosening the 7/16" nut that se-
cures each burner assembly down to the
control board. Slide each burner to the
side of the fireplace to remove. Note: it
may be easier to remove the light kit as-
sembly to access the 7/16" nuts securing
the burner assemblies.
3. Place log #N41-1 and log #N41-2 on cor-
responding pins on burner (not shown).
Logs must lie flat on media tray. Failure to
do so will negatively affect the flame
4. Place log #N41-3 on the corresponding
pin on top of #N41-2. Rotate the opposite
end of #N41-3 towards the back of the
fireplace.
5. Fill back media tray with crushed glass
media.
6. Place log #N41-6 on top of the crushed
media as shown.
7. Place the klinkers on the rear burner as
shown here. There are (2) smaller klink-
ers that need to go in the middle of the
burner where there is more porting. En-
sure no klinkers are placed on top of the
porting.
8. Place log # N41-4 so the right side of the
log aligns on the pin on top of #N41-3.
Place the left side of the log on the
platform in the center of the fireplace as
shown. Slide this log back towards the
rear of the fireplace on this platform.
9. Place log #N41-5 so it aligns with the pins
on #N41-1 and #N41-4 as shown.
Hussong Mfg. Co, Inc.
NDK-41-DV - PFS Report No. 22-838
Figure 9.6 - Log Set 1
Figure 9.7 - Log Set 2
45
Rev. 1 - May 2023
Starting Serial Number: 23 N41DV00001 23
Advertisement
Table of Contents
