VENTING (Top vent conversion instructions cont.)
INSTALL EXHAUST & COMBUSTION AIR INTAKE COLLARS TO FIREPLACE TOP
1
4
Tabs
Figure 17a
1.
Install 4" exhaust collar to fireplace top. Secure with (6) screws previously removed.
2.
Install 6-5/8" combustion air intake collar to fireplace top. Secure with (4) screws previously removed.
3.
Insert tab on heat shield cover (center previously removed) into slot on fireplace top.
4.
Insert tabs on top cover plate into slots at top of fireplace. Secure with (1) screw previously removed .
INSTALL COVER PLATES TO FIREPLACE BACK
WARNING: Cover plates must be installed on back of fireplace. Do not proceed with fireplace installation until this procedure is
completed. Follow instructions below.
1
Figure 17b
1.
Install 4" exhaust cover plate to fireplace back. Secure with (6) previously removed screws.
2.
Install combustion air intake cover to fireplace back. Secure with (4) previously removed screws.
3.
Insert tabs on outer cover into slots in fireplace back. Secure cover top with (1) previously removed screw.
2
2
PAGE 17
3
Tab
3
Tabs