8.4 #SP41-50A Log Set Installation
NOTE: Log numbers are located on the bottom or side of each log. Refer to the following instructions and illustration for proper
placement. Your components may look different than the ones shown.
CAUTION: Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and may cause
excessive soot to build upon the glass.
•
If converting to propane, complete the conversion before installing the log set. Follow the conversion instructions included
with the kit.
•
If installing a panel set, complete installation of panel set before log installation
1. Remove valance from fireplace.
2. Place log SP41-1A on the back log plate.
3. Align the holes in log SP41-2A with the mounting pins on the left front log plate. Push log down to seat.
4. Align the holes in log SP41-3A with the mounting pins on the right front log plate. Push log down to seat.
5. Distribute lava rock in front of the burner. Do not block burner ports or air spaces.
6. Align log SP41-4A with the notches in logs SP41-1A and SP41-2A.
7. Align log SP41-5A with the notches in logs SP41-1A and SP41-2A.
8. Align log SP41-6A with the notches in logs SP41-3A.
9. Distribute rockwool embers onto logs and burner using a stiff bristle brush. DO NOT block the area as shown below.
Hussong Mfg. Co, Inc.
SP-41, PFS Report No. 19-561
43
Rev. 9 - November 2023
Starting Serial Number: 23 96397 XX