INSTALLATION
1
Figure 32a
1.
Align hooks in upper louver to slots located in fireplace face. Set down into position.
2.
Insert upper hood flange into clips located at top of upper air passage, keeping in mind this is a fairly tight fit.
3.
Partially thread (2) screws (included in components packet) into nuts at each end of lower grill. Secure to fireplace by threading
screws into corresponding holes in inside flange of lower grill opening. The lower grill can now be opened and closed to access gas
valve and controls.
REMOVAL
1.
Use both hands to pull hood out of upper air passage clips.
2.
Lift upper louver up and out of slots.
3.
Remove screws securing lower grill at each end to remove from fireplace.
GRILL SET
2
Slide flange on upper hood into
clips in top of upper air passage
Upper hood
clips
PAGE 32
3
Thread screws into nuts on
each end of grill and secure
to lower grill opening.