Initial Setup; Gas Type Conversion; Continuous Pilot And Childproof Features; 56701-Ipi Remote Control Operation - kozy heat 56701 Installation And Operation Manual

56701-IPI REMOTE CONTROL OPERATION

INITIAL SET-UP:
Plug Extension Module and AC Adaptor into receptacles.
Install (4) AAA batteries into battery compartment of Backup Battery Pack , making sure batteries are installed in proper direction.
Position between valve and front of stove. A Velcro strip has been attached to help secure in place.
The Hand Held Remote operates on (2) 1.5V AAA batteries. We recommend always using ALKALINE batteries to extend battery life and
improve operational performance.
NOTE: This system is sent to you set up for Natural Gas and
temperature units readable in Fahrenheit.
This system allows for gas type conversion and temperature unit conversion by following the setup procedure outlined below.

GAS TYPE CONVERSION:

Press and hold Learn Button on Main Control Module for 20 seconds. A beep will be heard letting you know the procedure has been
completed.
If converting from NAT to LP gas: (1) one second long beep
If converting from LP to Nat gas: (3) three second long beep
Continue with gas type conversion by following instructions included with gas conversion kit.
CELSIUS/FAHRENHEIT CONVERSION:
Press UP and DOWN keys simultaneously to choose Celsius or Fahrenheit.
IMPORTANT SAFETY FEATURE:
This system has a maximum room temperature limit of 95° F (35° C) in both manual and thermostat modes. When room temperature is
at or above this point the system will shut down and the hand held remote control will read OFF. If you turn the system ON when room
temperature is still at or above this temperature, the system will again shutdown after 2 minutes when room temperature is recalculated.
CONTINUOUS PILOT FEATURE:
Activation of this optional feature is accomplished by pressing the
PILOT button once. The continuous pilot icon will appear on the
LCD screen. Pressing PILOT button again will de-activate this feature.
This feature can also be activated via CONTINUOUS PILOT switch on
Main Control Module.
CHILDPROOF FEATURE:
Activation of this optional feature is accomplished by pushing SET & UP
buttons simultaneously for 5 seconds. The childproof icon will appear on
the screen. When a transmitter button is pressed the icon will flash on
screen, but no signal will be transmitted. Pressing and holding these same
two buttons again for more than 5 seconds will de-activate this function.
This feature controls only manual functions of the hand held remote, au-
tomatic functions (thermostat mode) will not be effected.
.
Figure 43a
Figure 43b
PAGE 43