Table of Contents
Advertisement
8.4 #BH44-500 Log Set Installation
CAUTION: Do not place logs directly over burner portholes. Improper
log placement may affect flame appearance and cause excessive soot
to build upon the logs and glass.
Refractory panels or black glass panels must be installed. The following
pictures are shown without panels for clarity purposes only.
•
If converting to propane, complete the conversion before
installing the log set. Follow the conversion instructions included
with the kit.
Figure 8.6, Burner Stud Locations and Log Stop Brackets
Figure 8.7, Base Logs
#BHM-44 R.1 August 2020
Log stop bracket
Studs for log BH44-2
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
•
Log numbers are located on the bottom of each log. Refer to the
following instructions and illustrations for proper log placement.
1.
Using both hands, place log BH44-1 at the rear of the firebox, as
shown in Figure 8.7. Slide the log forward until it rests against
the log stop bracket flanges (Figure 8.6).
2.
Align the holes in the bottom of logs BH44-2, BH44-3, and
BH44-4 with the corresponding studs located on the burners.
See Figure 8.6 for burner stud locations.
Instructions continue on the following page.
Studs for log BH44-3
Studs for log BH44-4
Log stop bracket
FIREPLACE SETUP 51
Advertisement
Table of Contents
