Table of Contents
Advertisement
9.2 #CXL2-500 Log Set Installation
CAUTION: Do not place logs directly over burner port holes. Improper
log placement may affect flame appearance and may cause excessive
soot to build upon the glass.
•
If converting to propane, complete the conversion before
installing the log set. Follow the conversion instructions included
with the kit.
•
Log numbers located on the bottom of each log. Refer to
following instructions and illustrations for proper placement.
Figure 9.1, Log Set Installation
#CSK-335S R.6 December 2018
1.
Position the ember panel 2CX in front of the burner as shown.
2.
Align the (2) holes in the bottom of log 1CX with the (2)
mounting pins at the back of the burner. Push log down onto
pins to seat.
3.
Align the holes on the bottom of logs 3CX and 4CX with the
mounting pins on the burner. Push to seat.
4.
Align logs 5CX and 6CX with the notches on logs 1CX and 3CX.
5.
Align log 7CX with the notches in 1CX, 4CX, and ember panel
2CX.
6.
Align log 8CX with the notches in 1CX and 4CX.
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
GAS FIREPLACE INSERT SETUP 25
Advertisement
Table of Contents
