9.4 #RT29-501 Log Set Installation
CAUTION: Do not place logs directly over burner port holes. Improper
log placement may affect flame appearance and may cause excessive
soot to build upon the glass.
•
If converting to propane, complete the conversion before
installing the log set. Follow the conversion instructions included
with the kit.
•
Log numbers located on the bottom of each log. Refer to
following instructions and illustrations for proper placement.
Figure 9.5, Installation of RT29-501
#RVT-29-L R.2 July 2018
1.
Install refractory. Follow instructions included with the kit.
2.
Install the ash panel.
3.
Install log RT29-L1.
4.
Install logs RT29-L2 and RT29-L3.
5.
Place the rest of the logs as shown below.
6.
Use a stiff or steel bristle brush to distribute rockwool embers
onto the burner and logs.
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
23
GAS FIREPLACE INSERT SETUP