How To Set Extended Parameters - Toshiba TOSVERT VF-FS1 Instruction Manual

4.2.2

How to set extended parameters

The VF-FS1 has extended parameters to allow you to make full use of its functions.
All extended parameters are expressed with  and three digits.
Basic parameters

Press the MODE key once and use the
to select  from the basic parameters.
[Steps in key entry for extended parameters]
: Switches to the setting monitor mode.(Displays )
MODE
: Selects "" from basic parameters.
: The first extended parameter "" (Low-speed signal output frequency) is displayed.
ENT
: Selects the extended parameter whose setting needs to be changed.
: Reads the programmed parameter setting.
ENT
: Changes the parameter setting.
Saves the changed value of the extended parameter setting.
ENT
Pressing the
ENT
MODE
/ key
key instead of the key moves back to the previous status.
MODE ENT
D-5
E6581381
∼
Press the key or the key to
change the set value. Pressing
the ENT key allows the reading of
parameter setting.
⇒ See section 11.3 for
extended parameters.
4