Toshiba TOSVERT VF-FS1 Instruction Manual page 106

6.3.7
 : Frequency command agreement detection range
 : Frequency setting mode selection 1
 : Frequency setting mode selection 2
• Function
[Parameter setting]


6

Note: When using VIA terminal, set  or  respectively to 52 or 53 to put out signals to RY-RC or
Note: This function can be used, for example, to send out a signal indicating whether the amount of
Comparing the frequency command values
If the frequency command value specified using  (or  ) almost agrees with the
frequency command value from the VIA and VIB terminal with an accuracy of ±  , an ON or
OFF signal will be sent out.
Title Function
Frequency command agreement detection
range
Frequency setting mode selection 1
Frequency setting mode selection 2
FLA-FLB-FLC.
When using VIB terminal, set  or  respectively to 60 or 61 to put out signals to RY-RC or
FLA-FLB-FLC.
processing and the amount of feedback agree with each other when the PID function is in use.
⇒ For an explanation of the PID function, see section 6.14.
Adjustment range
0.0 ∼   ( Hz)
1-5
F-14
E6581381
Default setting
2.5
1
2