Toshiba TOSVERT VF-FS1 Instruction Manual page 61

4.2.6
For safety reasons, the following parameters have been set up so that they cannot be reprogrammed while
the inverter is running. Stop operation ("" or "" is displayed) before changing parameter settings.
[Basic parameters]









4
[Extended parameters]
∼ : Input terminal selection parameters
∼ : Output terminal selection parameters


∼ : Protection parameters


∼ : Motor constant parameters
∼ : Motor control parameters








∼ : PM motor parameters
The setting of any parameter other than the above can be changed even during operation.
Keep in mind, however, that when the parameter  (prohibition of change of parameter settings) is set to
 (prohibited), no parameters can be set or changed.
Parameters that cannot be changed while running
: Automatic acceleration/deceleration
: Parameter setting macro function
: Command mode selection
: Frequency setting mode selection 1
: Default setting
: Maximum frequency
: Base frequency 1
: Base frequency voltage1
: V/F control mode selection 1
: Base frequency 2
: Base frequency voltage 2
: Carrier frequency control mode selection
: Auto-tuning
: Stall prevention level 1
: Emergency stop selection
: Output phase failure detection mode selection
: Input phase failure detection mode selection
: Detection of output short-circuit during start-up selection
: Over-voltage stall protection level
: Under voltage trip/alarm selection
: Prohibition of panel local/remote operation (
D-10
Set , and they can be changed while
the inverter is running.
LOC
key)
REM
E6581381