[Parameter setting]
Title
Frequency setting mode selection 1
Frequency priority selection
Frequency setting mode selection 2
1) External switching (Input terminal function 38 : FCHG enabled)
Frequency priority selection parameter =
Switching between the command specified with and can be made by entering a command
from a terminal board.
To do so, however, the frequency command forced switching function (input terminal function selection: 38)
needs to be set beforehand to an input terminal board.
If an OFF command is entered to the input terminal board: The command specified with will be
selected.
If an ON command is entered to the input terminal board: The command specified with will be
selected.
2) Automatic switching by frequency command
Frequency priority selection parameter =
The switching between the command specified with and is done automatically according to
the frequency command entered.
If the frequency set with is above 1Hz: The command specified with will be selected.
If the frequency set with is 1Hz or less: The command specified with will be selected.
Function
1: VIA
2: VIB
3: Operation panel
4: RS485 communication
5: UP/DOWN from external
contact
0: ( Switchable to
by the input terminal)
1: ( for output
frequencies equal to or lower
than 1.0 Hz)
1: VIA
2: VIB
3: Operation panel
4: RS485 communication
5: UP/DOWN from external
contact
F-17
Adjustment range
Default setting
E6581381
1
0
2
6